Zephyr ZML-E42BS Guide d'installation télécharger pdf (Page 14)

www.zephyronline.com

FIG. J

Top duct covers

Top support frame

Bottom duct covers

Bottom support frame

Thick trim piece (top)

Thin trim piece (bottom)

cut trim piece

if necessary

12. *Secure top duct covers (with louver holes) to top support frame using (2) M4 x 8 truss head screws. (FIG. J, #1).

Note: If using hood in “ducted mode” the top duct covers may be turned upside-down to hide the louver holes.

13. Assemble top duct covers together using (3) M3 x 5 screws on each side. (FIG. J, #2). Larger screw hole openings

should overlap the smaller holes.

14. Assemble bottom duct covers together over top duct covers using (3) M3 x 5 screws on each side. Bottom duct

covers will rest on top of the hood body. (FIG. J, #3)

15. Insert the (2) thin trim pieces into left and right seams of bottom duct covers. (1 on each side) (FIG. J, #4)

16. Insert the (2) thick trim pieces into left and right seams of top duct covers. (1 on each side) (FIG. J, #5)

Note: Because less of the top duct covers will be exposed, it may be necessary to measure and cut the thick

trim pieces before installing them into the top duct covers.

* If using hood in recirculating mode you must install the air diverter plate before assembling the duct covers.

Turn to page 13 for instructions.

Installation – Mounting the Hood

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Pas de commentaire

Zephyr ZML-E42BS Guide d'installation Page 14