Zephyr ZMO-E30AS Manuel télécharger pdf

RC-0001 DCBL Remote Installation Instructions

2277 Harbor Bay Pkwy

1.888.880.8368

Alameda, CA 94502

1. Locate Main PC Board on top of blower

housing of hood body. Remove (4) Main

PC Board cover screws.

2. Remove Main PC Board from PC Board box. Use

caution when removing Main PC Board as to not

disconnect any wires

4. Install Remote Module into Main PC

Board box by (2) screws.

5. Re-install Main PC Board into PC Board box.

Be sure blue antenna wire from Remote Module

is outside of PC Board box. Turn to page

2 for remote synchronization & features.

CAUTION: Hood must be disconnected from main power prior to performing the conversion

instructions listed below. Failure to do so could result in personal injury or damage the hood.

Inclided Materials: 1 Remote Module w/antenna

wire, 1 Remote control, 1 Remote control holder,

1 battery, 2 screws.

Page 1

3. Disconnect black switch cable A from Main PC

board and connect it to the Remote Module terminal.

Connect white cable B from Remote Module to Main

PC board switch terminal.

1 2

Résumé du contenu

Page 1 - Alameda, CA 94502

RC-0001 DCBL Remote Installation Instructions2277 Harbor Bay Pkwy1.888.880.8368Alameda, CA 945021. Locate Main PC Board on top of blowerhousing of hoo

Page 2

RF REMOTE MAINTENANCE:Clean the remote control using non abrasive detergentsFollow instructions below for replacing battery.

Commentaires sur ces manuels

Pas de commentaire

Zephyr ZMO-E30AS Manuel

Naviguer en ligne ou télécharger Manuel pour Non Zephyr ZMO-E30AS. Zephyr ZVNE42AG User manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Zephyr ZMO-E30AS